For those with enclosed trailers which Race Ramps are you using for loading

[HR213]

Looking at the various Race Ramp models against the preferred flat bed method specs in the owners supplement which specify 7 degrees max and 70 inches minimal length.

Looks as if most keep there ramp extension flipped back then spec out the appropriate size to keep your ramp angle below 7 degrees.

These will be for a 20' enclosed Interstate trailer.

Thanks!!

Sponsored

 

[Mach4.6]

Here's what I use on my R to load, my car is pretty low the front splitter is 3.625" from the ground

Race Ramps RR-TR-8 8" Trailer Ramp
https://www.amazon.com/gp/product/B003ZABBO6/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

Race Ramps RR-EX-14 67" Xtender
https://www.amazon.com/gp/product/B003ZAEOHW/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

 

[Muligan]

RR-TR-7

Here's a pic of them - they also make a version that has a little depression near the high-point for the flip-out portion of a rear trailer door / ramp.

Paid just under $365 with free shipping from Summit Racing just last week.

 

[HR213]

RR-TR-7

Here's a pic of them - they also make a version that has a little depression near the high-point for the flip-out portion of a rear trailer door / ramp.

Paid just under $365 with free shipping from Summit Racing just last week.

Has this one been tested with an R?

Thanks!

Mitch

 

[Muligan]

Has this one been tested with an R?

Thanks!

Mitch

My test fit with a non-R that has an R splitter was successful, but the actual R does ride a bit lower. I'll test it in a month or so when my '18 R arrives and report back.

Sponsored