Lonmon
Well-Known Member
- Joined
- Jul 17, 2015
- Threads
- 17
- Messages
- 716
- Reaction score
- 275
- Location
- Mid East US
- Vehicle(s)
- 2018 Mustang GT 10spd Base
- Thread starter
- #1
Just curious if anyone else replaced their clutch and flywheel and reused the bolts for each. I did not realize before doing the Exedy clutch and flywheel that the bolts were torque to yield. Since I had the car apart on the lift and all other parts in hand I just reused the factory bolts (only 7300 miles on them) using the factory torque sequence and blue thread locker. I have about 300-400 miles on it with some hard pulls on it so far with no issues. If any of you have experience with reusing the flywheel or PP bolts with good luck I would love the info for peace of mind. Of course the bolts did not show any visual sign of stretching but I did not measure them either. Next time I have it apart I will certainly replace them with some ARP's. :headbonk:
Sponsored