Phils15GT
Well-Known Member
- Joined
- May 13, 2015
- Threads
- 37
- Messages
- 713
- Reaction score
- 156
- Location
- Albany, NY
- Vehicle(s)
- 2018 Mustang GT
- Thread starter
- #1
Installed startup tune on my car after a shop installed turbo kit. They went to start the car up and It fires up but instantly stumbles, then dies. I was able to log a very short clip of it but the measured AFR bank 1 and 2 stay at 0.00 the entire time. Does the car need to be running for a certain time before these begin to read or is there something else wrong?
I sent tuner the log but I won't hear back from him until next week. I am just trying to ensure it isn't anything mechanical that I should address before he gets to it. Shop looked over the car numerous times and sees no mechanical issue.
19 GT, auto with Hellion sleeper kit, ID1050x, JMS BAP, E85. SCT BDX
I sent tuner the log but I won't hear back from him until next week. I am just trying to ensure it isn't anything mechanical that I should address before he gets to it. Shop looked over the car numerous times and sees no mechanical issue.
19 GT, auto with Hellion sleeper kit, ID1050x, JMS BAP, E85. SCT BDX
Sponsored