SlowyoteJay
Well-Known Member
- Thread starter
- #1
Alright guys, I’ve been trying to figure this out on my own for the past 3 days and can’t seem to figure it out. I installed the new cobra jet intake manifold, and apparently I have a vacuum leak somewhere but I can’t figure out where and p0443, p0300, and p0316 codes. I got the Steeda max flow closed box air intake.
I have the passenger side pcv hose connected, ran the brake booster straight to the drivers said of the intake manifold (so deleted the evap hose and sealed of the opening that sits under the brake booster), and blocked off one of the openings in the rear drivers side of the intake manifold (not sure what it would be used for). I’ve triple checked the silicone hoses that connect the intake elbow to the throttle body and air filter, and they are secured. I did have to make a hole in the intake elbow to put the valve the drivers side pcv and it doesn’t fit snug. Like when the pcv hose is connected, it pulls the valve a little.
Oh and it is tuned.
Could that be where the leak is coming from? I was going to buy/make a pcv breather for the drivers side and either replace that elbow with a new one to delete that valve or just get a PMAS intake but wanted suggestions first
Oh and it is tuned.
Could that be where the leak is coming from? I was going to buy/make a pcv breather for the drivers side and either replace that elbow with a new one to delete that valve or just get a PMAS intake but wanted suggestions first
Sponsored