whatdoyoufeedit?
Well-Known Member
- Joined
- Jan 14, 2015
- Threads
- 10
- Messages
- 582
- Reaction score
- 208
- Location
- Fayetteville, NC
- Vehicle(s)
- 2019 Race Red EB A10 (Formerly 2016 3X Yellow V6 M6), 1996 Mercury Cougar XR7 4.6L A4 (Future Coyote swap candidate)
- Thread starter
- #1
Hi all, I just installed CVF hot/cold pipes and ATM IC and now I am getting a trumpet noise sounding boost leak upon acceleration. I made sure all the clamps were tight and the couplers had plenty of area on the tubes to get the clamps on. Could the leak be coming out of the bung for the meth port? I did use teflon tape there but perhaps that is not sufficient? Any help could be appreciated, I am almost tempted to just go back to the stock hot/cold pipes. :(
Sponsored