Sponsored

Anyone put lower rear gears in a 10R80 car?

Thread starter 19gtaz
Start date Apr 10, 2021
Watchers 1

19gtaz

Well-Known Member

Thread starter
#1

It doesn't seem to be popular.

Sponsored

LSchicago

Well-Known Member

#2

Too much low with first gear as it is. Wouldn't be bad to have 3.73 or 4.10 if you eliminated first, but then you'd be hitting 7th in the 1/4.

2018 Mustang GT/A10. Mid level 301A, Kona Blue, Blk Acc Pack, Active Exhaust, 3.55LS. 11.92/118.39 when bone stock on factory 255's. Best to date: 10.20/138 with a Procharger P1X/4.00" pulley (let off early, ground issue)
*Mods: Procharger Stage 2 P1X, ~~4.5"~~ ~~4.25",~~ ~~4",~~ 3.5" Griptec 17+PSI on E85, LUND 93/E85 Tunes, MAK 4.5" Hurricane inlet. Jackal JR Fuel system with twin walbro 525's, PTFE lines & rails, FIC 1000's, NGK 6510 (.024), Reische 170*.
Steeda STH starter kit & drag springs, GT350 Axles & Steeda Rear Diff support with black bushing inserts.
CM components rear seat delete, Steeda Lightweight front bumper bar, DSS aluminum DS.
SVE SP2 19X10 with 285/35 Nitto Invo's & 17X10.5 Drag Star's with 315/50/17 ET Street R's.
Cervini's C series grilles, Big Worm Graphics, Motorsport hood vents.

OP

OP

19gtaz

Well-Known Member

Thread starter
#3

LSchicago said:
Too much low with first gear as it is. Wouldn't be bad to have 3.73 or 4.10 if you eliminated first, but then you'd be hitting 7th in the 1/4.

Yea, that's what I was thinking after looking at the trans gear ratios.

Sponsored

You must log in or register to reply here.

Share:

Facebook Twitter Reddit WhatsApp Email Link