Lexsmf
Member
- Thread starter
- #1
My version 3 accessport came in today and I installed it on my ecoboost. The only modifications I have right now are a axle back exhaust and a cold air intake. I went with the stage 1 at 93 octane tune and installed it on to my car with ease. Took the car for a very short drive and it's almost as if there is a boost leak somewhere because I have almost zero torque off the line. The car will pretty much crawl till about 2500 rpm then will get up and go. All in all it's pretty much slower than stock right now and I'm not certain as to why. I checked the couplings and everything seemed to be tied down correctly and accessport is reading that I'm still building a little over 20 pounds of boost. Does anyone have any advice on this matter as I'm not mechanically inclined.
Thank you!
Thank you!
Sponsored