Imma Sssnaake
Well-Known Member
- Thread starter
- #1
Looking to sell my 2018 GT350 in lead foot grey, I bought it almost three years ago with 5,500 miles. After about 4,000 stock miles I added the Whipple and all the other parts. Since then the car has been super reliable and have not run into any issues (currently at 11,342). No corners were cut on this build. Every piece of textured plastic that used to be on the exterior has been changed to carbon fiber from Anderson Composites. It was built by Danny Built Racing in Woodstock, Ga. and tuned by Lund Racing through an RTD device. It was never dynoed but with this current setup it should be in the mid to high 700s at the tires. It’s scary fast and very fun, any questions can be DM’d to me or at 4zero4-2nine0-one2eight8
Asking $60,000
Engine:
-Gen V 3.0L Whipple (3.875 pulley)
-Whipple over sized heat exchanger
-Kooks stepped headers
-Off-road x-pipe
-American Racing resonators
-Boundary billet OPG/CS
-MMR head cooling mod
-Archetype oil balancing lines
-Adler radiator
-170° thermostat
-JLT catch cans (driver and passenger side)
-Denso spark plugs
-Tuned by Lund Racing
Fueling:
-DW1000 injectors
-Dual BAPs
Drivetrain:
-Mantic twin disc cerametallic clutch
-Lightened flywheel
Suspension:
-FP lowering springs
-FP sway bars
-Maximum Motorsports camber plates
Appearance:
Anderson Composites-
-Carbon GT350 hood
-Carbon grille inserts
-Carbon front bumper inserts
-Carbon turn bezels
-Carbon side skirts
-Carbon rear valence/diffus
-Carbon valve covers
-Carbon dash
-GT500 spoiler
-Euro tail lights
-Signature Wheels SV902 19x11 front 19x11.5 rear
Asking $60,000
Engine:
-Gen V 3.0L Whipple (3.875 pulley)
-Whipple over sized heat exchanger
-Kooks stepped headers
-Off-road x-pipe
-American Racing resonators
-Boundary billet OPG/CS
-MMR head cooling mod
-Archetype oil balancing lines
-Adler radiator
-170° thermostat
-JLT catch cans (driver and passenger side)
-Denso spark plugs
-Tuned by Lund Racing
Fueling:
-DW1000 injectors
-Dual BAPs
Drivetrain:
-Mantic twin disc cerametallic clutch
-Lightened flywheel
Suspension:
-FP lowering springs
-FP sway bars
-Maximum Motorsports camber plates
Appearance:
Anderson Composites-
-Carbon GT350 hood
-Carbon grille inserts
-Carbon front bumper inserts
-Carbon turn bezels
-Carbon side skirts
-Carbon rear valence/diffus
-Carbon valve covers
-Carbon dash
-GT500 spoiler
-Euro tail lights
-Signature Wheels SV902 19x11 front 19x11.5 rear
Sponsored