2018 GT350 A-Pillar Tweeters

[ClayDee]

What size am I looking at? 1 inch or 3/4, or will either size work? Currently looking at the JL Audio C3-100ct. Any suggestions is appreciated.

Sponsored

 

[Chef jpd]

3/4 will fit under the factory grille.
1" will work if you want to use the aftermarket tweeter cover. Perhaps some light trimming.

 

[ClayDee]

3/4 will fit under the factory grille.
1" will work if you want to use the aftermarket tweeter cover. Perhaps some light trimming.

Thanks for the response and info.

 

[StangTime]

This Hertz MP25.3 tweeter was installed by opening up the A pillar hole with a Dremel to 1.6 inches. Made the hole tight enough to friction fit the tweeter so it can be removed without taking the A pillar off again. The connector was removed from the OEM tweeter and epoxied to the back of the new tweeter.

 

[ClayDee]

This Hertz MP25.3 tweeter was installed by opening up the A pillar hole with a Dremel to 1.6 inches. Made the hole tight enough to friction fit the tweeter so it can be removed without taking the A pillar off again. The connector was removed from the OEM tweeter and epoxied to the back of the new tweeter.

You run these with the stock head unit? If so how do they sound?...

 

[StangTime]

You run these with the stock head unit? If so how do they sound?...

Everything after the head unit was replaced. New amp and DSP. Full active 2-way system with subwoofer. Sounds great.

These are the mid-bass drivers that are part of a 2-way component set with the tweeters: Hertz MPK165P.3

 

[ClayDee]

Very nice. Very clean.

Sponsored