I actually made up a set of drawings. Just haven't found a local shop to do the work.I just had a complete bracket and lockout set made out of aluminum from a forum member's drawings.
Just find a panel shop - I had one fashion me up a fix in a few hours. Sits a few mm higher than the stock manifold, but still easily fits under the strut brace.I would really like to use my 17 engine cover again. Is anyone making or selling brackets? Seems like this is a good business opportunity.
We are talking about 17 engine covers, not 18!I hated my 18 engine cover and just cut the center section out and threw it back on.
I know this, Captain Obvious. I had looked for an older engine cover before modifying mine.We are talking about 17 engine covers, not 18!
Could you share the drawing/ file of these mounting brackets?I just had a complete bracket and lockout set made out of aluminum from a forum member's drawings.
https://www.mustang6g.com/forums/th...-on-show-off-thread.91334/page-2#post-2388789Could you share the drawing/ file of these mounting brackets?