1st Mods on 2020 GT500

[protraxduner]

I have all the braces and pucks and my rear end is rock solid. However my NVH is worse than i like, i was told it was the urethane diff pucks, initially it was unbearable(compared to stock)....now i am used to it and they were a PITA to install so i have just left them.

 

[Houston Kid]

I don’t see any wheel hop on HPDE’s either. But the rear feels more controlled accelerating off the corners. Can really get the power down confidently.
And high speed corners feel rock solid. As in my avatar, taking the tower turn at 85-90 feels great.

I will add as far as stopping the hop, 100% work. My 5.0 pre-kit had horrible hop at the strip. After, none. The kit definitely works as advertised for stopping the hop.

 

[Calif-GT500]

My first mod is Orange tape to apply over the white stripe on the steering wheel. I'm going all in! lol

 

[09cs]

My first mod is Orange tape to apply over the white stripe on the steering wheel. I'm going all in! lol

Any chance you're in the Malibu/Santa Monica area?

 

[Calif-GT500]

Any chance you're in the Malibu/Santa Monica area?

No I'm in Nor Cal San Francisco Bay Area.

 

[ndpace]

@Calif-GT500 I want to do my steering wheel as well. did you find a good source that matches well?

 

[The Chairman]

@Calif-GT500 I want to do my steering wheel as well. did you find a good source that matches well?

From Home Depot electrical section:

 

[Calif-GT500]

@Calif-GT500 I want to do my steering wheel as well. did you find a good source that matches well?

I found this place from a thread here on Mustangs6G

Here is the thread
Mustang6G Thread

Here is the one I bought
Zimcraft

Also this place referenced in the thread
Bemaro Films

 

[The Chairman]

I found this place from a thread here on Mustangs6G
Steering Wheel Tape

Here is the thread
Mustang6G Thread

Also this place referenced in the thread
Bemaro Films

The Zimcraft stripe is too narrow and paper thin. I conversed with the guy about the width, but he didn’t want to make it wider.

 

[Calif-GT500]

Dang I'm still waiting for mine to arrive.

 

[09cs]

No I'm in Nor Cal San Francisco Bay Area.

Ah saw your twin on PCH this weekend

 

[Calif-GT500]

I have yet to see another GT500 of any color near me.

 

[fishpick]

@Warpath how did the install go?

 

[Warpath]

@Warpath how did the install go?

Still going. I like to take my time. All I have left is the pulley kit. Then tweak my tune.

 

[ndpace]

@Warpath how did the Steeda jacking rails fit? any feedback on the quality and effectiveness? I wanted to order while they are on sale if they are worth while. thanks, jim