2016 hood turn signal wire removal

anyone know how to remove the wires that route down into driver fender without cutting

[MENTION=8761]Jmeo[/MENTION] may be able to tell you he used a factory harness when he added them to his 2015.

Just curious, but why would you want to remove them ?

Roush hood vents

Sent from my SM-N910W8 using Tapatalk

I removed my blinkers, but left the wires under the hood blanket. Ready to go if I sell the car.

Don't like bringing up a dead thread but has anyone figured out how to remove the cable or where it plugs into? My hood liner is currently out and I don't want open plugs just flopping around.

The harness going from the signals runs to a plug behind the driver fender. You should be able to access the plug if you pull back the fender liner and then remove a black covered foam piece that's tucked in behind the fender. Heres a pic of the location of the plug.

Untitled by Tom Francis, on Flickr