- Thread starter
- #61
test yet?I am going to try mine with the intake off when it is cooler out. When I tried it it was 95 degrees and DA was 2500ish.
Sponsored
test yet?I am going to try mine with the intake off when it is cooler out. When I tried it it was 95 degrees and DA was 2500ish.
What intake is that?
What intake is that?
never to late to party!I’m late to the boost party, but I’m very excited to have just ordered the Beefcake Special Paxton Stage 2 3.6/BV57 BOV for my 15 PP GT. Hopefully I can get it installed before heading to Hot Rod week in York, Pa on June 1st and 2nd. Thanks again for everything Terry. Now I need to find someone who wants to buy a slightly used GT350 intake manifold ��
Why are you trying to sell that manifold. I use a gt-350 manifold and tb with my boosted set up and its awesome...I’m late to the boost party, but I’m very excited to have just ordered the Beefcake Special Paxton Stage 2 3.6/BV57 BOV for my 15 PP GT. Hopefully I can get it installed before heading to Hot Rod week in York, Pa on June 1st and 2nd. Thanks again for everything Terry. Now I need to find someone who wants to buy a slightly used GT350 intake manifold ��
I had a change of plans build wise. Now that im going F/I, I want to try this out for a bit and get used to it. Also I’m trying to not go overboard yet, this is my DD and I don’t want to push it too far. I figure if I sell the intake I can put the money towards getting upgraded half shafts or a clutch. Unfortunately the intake is at the speed shop so I can’t take pictures of it, but I’ll be asking $725 if you know anyone that’s interestedWhy are you trying to sell that manifold. I use a gt-350 manifold and tb with my boosted set up and its awesome...