Braski
Well-Known Member
- Joined
- Feb 4, 2015
- Threads
- 79
- Messages
- 2,084
- Reaction score
- 957
- Location
- Lancaster, PA
- Vehicle(s)
- Traded 2015 Blk GT Prem PP on 2019 Corvette GS 2LT M7
- Vehicle Showcase
- 1
- Thread starter
- #1
Just curious if anyone else ran into this problem? The template that came with the spoiler is about 1'' larger from side to side than it should be. I took measurement with a tape and compared them to the measurements on the template just to verify I'm not nuts. Also when laying template on spoiler the holes are off big time. I'm glad I didn't just center it up and start drilling. I contacted the vendor to see if they can mail me a new one. There is no good way to mount it with out the correct template because the alignment pins and studs are attached to the spoiler so you cant fit it and use the strip method. If any one has there old one and is close by bring it over so I can install this bad boy! Beers on me!:cheers:
Sponsored