CJ Pony Parts
Well-Known Member
- Joined
- Dec 21, 2015
- Threads
- 151
- Messages
- 1,290
- Reaction score
- 404
- Location
- Harrisburg, PA
- Website
- www.cjponyparts.com
- Vehicle(s)
- A large variety of Mustangs across all generations
- Thread starter
- #166
I would recommend contacting stainless works/stainless power and picking up a set of the pipes that utilize the factory connection point. This way everything can remain a bolt-on process at that spot. But that still will not solve the 3" out. From the sounds of it, you would have to have a competent exhaust shop modify everything to fit.I have the stainless power o/r headers with a performance connect that connects up to 3 inch solo performance cat-back. I cannot stand the rasp that is produced from this setup so I am looking into this to take care of some of it. Is there anything you would recommend that would to neck down my headers to work with this system? Or have the come out with a 3 in/out for this setup yet?
We have no plans of releasing this with a 3" in/out.
Sponsored