Luisiv32
Well-Known Member
- Joined
- Jan 16, 2017
- Threads
- 15
- Messages
- 90
- Reaction score
- 8
- Location
- Oak harbor wa
- Vehicle(s)
- 2017 Magnetic Mustang GT
- Thread starter
- #1
I was installing a throttle body spacer and when tightening up the top right bolt on the throttle body I must have tightened it too much and the bolt broke. It would not tighten anymore, it was just spinning. I took off the throttle body and spacer and noticed that the end of the bolt brok off and is now in the intake manifold. I can't take it out because it is flush and I tried to drill it out but the bit I had was not strong/big enough and did not make much of a dent. I don't know what to do right now. I know it might have been a stupid thing to do but it was a mistake. I'm in the military and leave for a month next week so I really hope I can fix this. Any advice?
Sponsored