asylum938
Well-Known Member
- Thread starter
- #1
Ok so I've been fighting with this for a few hours now and could use some input.
I'm installing an exedy Twin disc, used the alignment tool and it goes smooth right through both discs and into the pilot I now have the trans about an inch from the block.
The Input shaft seems to go through both disc and the throw out bearing is just touching the pressure plate fingers but it refuses to go any further.
Does it need a good push to overcome the throw out or should it just slide eight in?
I did bench bleed the throw out so maybe that's my problem?
I'm installing an exedy Twin disc, used the alignment tool and it goes smooth right through both discs and into the pilot I now have the trans about an inch from the block.
The Input shaft seems to go through both disc and the throw out bearing is just touching the pressure plate fingers but it refuses to go any further.
Does it need a good push to overcome the throw out or should it just slide eight in?
I did bench bleed the throw out so maybe that's my problem?
Sponsored