Can I run a Centri without BAP?

smokinzx14r · Jun 19, 2018

I was out of pump with a 3.70 pulley with ID1000 injectors @ 6900 RPMs 604 HP on 93 pump gas .. I added a plug and play BAP and it was safe with my 3.50 pulley @ 7200 ... After that went E85 and sold the BAP and went with a Si Li fuel system ..

MikeyPee · Jun 20, 2018

markmurfie said:
If you install it yourself, which you should cause it is soo easy. Make sure you give it a very good ground. Sand paper and a drilled and tapped hole for a bolt to hold it down to the frame/body. I've personally done it and have seen too many not give their boostapump a good ground and 1: not get the benefit 2. probably kill their pump from the varying voltage caused by the bad ground.

THIS...

Who knows if my BAP was doing anything, when I had it installed. I re-used the BAP ground for my FORE system (FPDM), and I traced an open to the ground point. Stripped some paint and grounded it directly to the car frame, and everything is perfect now

beefcake · Jun 20, 2018

SVT-DADDY said:
[MENTION=10926]beefcake[/MENTION] Why is the air so much more expensive than the fuel?

lol

stang17 · Jun 21, 2018

I'm currently running the Whipple Stage 2 Gen 2 kit with 3.625 pulley on 93 octane. 78lb injectors on stock pump without BAP provided no problems running 12-13psi. Data logs were spot on and made 786 whp on DYNAPACKs.

I posted a copy of the log file from HP Tuners over here if you wanted to check it out.

https://www.mustang6g.com/forums/showthread.php?t=103976&page=2

Can I run a Centri without BAP?

smokinzx14r

Well-Known Member

MikeyPee

dissmember

beefcake

Well-Known Member

stang17

Well-Known Member