BlownOne
Horsepower Fiend
- Joined
- Apr 14, 2017
- Threads
- 22
- Messages
- 509
- Reaction score
- 191
- Location
- Sacramento, Ca
- Vehicle(s)
- Anything with wheels
- Thread starter
- #16
I received my Blowfish Racing firewall and intake plugs so I finally get that contraption out of the way. The 10mm nut takes some patience but with a few 1/4" extensions and a universal, it will happen. Juts need to use a deep 10mm to get the party started and once it starts to bind, swap to a shallow 10mm to finish it off. Then I added some breather filters my buddy gave me and used 5/8" vacuum caps to plug the valley and intake tube.
Also I plasti dipped my dash trim yesterday, but I didn't take any pictures along the way. Trim comes off with a little muscle and you are bound to lose atleast one clip doing it. Two 7mm bolts are hiding under the driver side and center lower plastic trim so you have to pop them off first. A/c ducts pop out and so does the light control switch. Strung them up with bailing wire and hit them with 4 or so light coats followed with 2-3 medium for complete smooth coverage.
Also I plasti dipped my dash trim yesterday, but I didn't take any pictures along the way. Trim comes off with a little muscle and you are bound to lose atleast one clip doing it. Two 7mm bolts are hiding under the driver side and center lower plastic trim so you have to pop them off first. A/c ducts pop out and so does the light control switch. Strung them up with bailing wire and hit them with 4 or so light coats followed with 2-3 medium for complete smooth coverage.
Sponsored