Search results

I purchased stripes from Big Worm last fall. They are wider at the back of the hood (this is stated in the installation instructions). I have a different style than yours, so measurements won't help you, but the narrow end of the hood stripe goes toward the front, and should be the same width as...

I had a couple of very light scratches above one of the rear wheels that didn’t reach the color. I wet sanded them out with 3000 grit trizac, and then a 4 step cut and polish process and all was fine.

Tiresize.com has a handy tire size calculator for comparing tires side by side.

Re-installed the infamous engine cover after painting it and adding some white vinyl. Paint is single stage race red over black epoxy primer. I cut the dashed stripes from a bigger piece, and the center vinyl piece was bought off of E-bay. I like how it turned out.

I guess it depends on the person looking at it. I hate the look of wheels leaning in at the top. I am at -.5 degree on all four corners and notice no difference in handling the way I drive.

Ah yes, it's coming back to me now. '22 and '23, I'm getting old and forgetting what I have read.

It seems like I've read a lot on these forums about the extra restriction in the '18 and up air intakes. Even after removing the extra carbon filter you still are left with the lattice that holds it in. And even if you remove the lattice, you still have the honeycomb plastic in there. Is there...

I have a Juggernaut 93 octane tune on my '22 6-speed. The biggest difference I noticed is the power at lower rpm's. It improved the low rpm bog. I've never had it on a dyno, so I don't know the actual HP improvement. It's probably not alot, but car feels much better taking off from a stop. The...

And another

Race Red back TTT.

It looks like Rokblokz offers two sizes. Do you know which size you had?

ZL1 Addons Mustang 15-23 GT500 Style Side Skirt Extensions - 2018-2023 Mustang GT w/ Performance Pack - With Rock Guards - 22159604 Does anybody have these on their S550. Seems to me it would offer more rock protection than a mud flap alone. Just not sure if it would look out of place without...

No magneride on my car.

When I had the PP wheels on my ‘22 with 25mm all the way around the front were perfect but the rear poked just a little bit. A 20mm in the rear would probably have been closer to flush.

Yes, just an enable/disable choice.

My’22 was the same way. Parking lights would also be on. Found out it originally was shipped to Canada and they required it. I disabled both of these with Forscan.

Just passing on what I have read. Direct injection can cause the oil to be contaminated quicker which is why they went to a 10 qt system. Might be better to get the contaminated oil out of the engine before it sits for months. Not something I personally would worry about though. Just another...

I carry the gun in my Mustang the same place I always carry, on my right hip (I'm right handed). If the gun would need to be used, my right hand goes down and unbuckles the seat belt, acquires the firearm and draws all in one motion. Gun comes out with muzzle pointing straight forward, up and...

I also did not see the text under the big picture in the original post. For some reason I always look at the top. I guess you would have caught worn out brake pads when you had it apart.

I've seen rotors that look worse than the picture above due to worn out pads and the driver had no idea there was a problem. As a mechanic in my earlier days I seen this with my own eyes.