Dealing with this right now. The last couple of weeks I have been blowing out acorns from off the top of the engine and out the belly pan. Tried Irish spring soap shavings but that didn’t help. Bought a couple of battery powered ultrasonic sound emitters and mounted one under the hood on the...
Just scrape away the paint from the bracket and bolt. This is what I have always done. Makes for a good ground point. Also I would not run the grounds to the battery. You want to keep the ground length as short as possible. Also what amplifiers are you using that fit under the seats? There is...
mods are the following
S&B cold air intake
Mishimoto clone street intercooler
Roush catback exhaust
JLT oil catch can
Turbosmart 12psi wategate
Cobb accessport
93 octane PD tune with A10 transmission tune
And then have suspension mods from Ford Performance and BMR. Snow Performance just came...
Tuned by Ryan @ PD tuning here. He is very patient and the process was great. He starts off very conservative with the tune and it builds up with each revision. On the 93 octane tune we went through a total of seven revisions. Then latter I went and added a Turbosmart 12psi wastegate and went...
What other supporting mods have you done? The very first one should be the intercooler. Fresh set of properly gapped spark plugs also.
In your pic for the Ing correction that is not a negative value. You will get a negative corrections but as long as they are not going up shouldn’t worry about...
So you have a tune but no intercooler? Then I would definitely get the intercooler. That should be the very first thing to be upgraded before anything else.
What mode are you driving it in? I always drive my 2020 in either sport/sport + all the time, never in standard drive mode. I also have the the add on trans tune from PD tuning and it shifts fast and crisp.
Thanks for the replies everyone. I will take a look at them next weekend. Will also be installing the other BMR components. I will update this thread once I do. Thank you
I put tension on them to get the top bolt holes to line up so I could get the bolts through. Once the bolts were in I let tension from the Jack down and torqued them. I am going to be installing the rest of the BMR stuff next weekend so I wi check them. But I went ahead and repeated pulling into...
Hey everyone,
the other week I swapped out vertical links to BMR poly links. I also picked up the BMR differential bushings and level 2 IRS lockouts but have not installed them yet.
So today while turning into the driveway my wife and I heard a loud pop sound come from the back. I thought I...
Great, sounds like you covered all the “main” things to replace.
I too also have a JLT catch can, you may want to check the fittings on it to make sure they are snug. Check and make sure hose clamps and tight. But I also agree that it just may be one of the characteristics of your car. Mine...
Have you checked for any pending codes?Spark plugs been replaced? Low pressure fuel sensor and purge valve been replaced? Check and see if you have the newer LPFS.
Escort Max 360c MKII. The directional arrows really help to let you know where they are at. Have not really had any false alerts around town. I power it using a rear view mirror tap for ease of installation.
Thanks for the replies everyone,
I was curious too after reading all the other threads about “toe and camber” settings.
The car is primarily street use but the wife and I do like to drive it spirited on country back roads. I told the tech that was performing the alignment how we drive the car...
Hey everyone,
wasn’t sure if I should post this in this section or in the “wheels and tires” section.
I have a 2020 ecoboost that I lowered using Ford Performance springs about two years ago. I always meant to get it an alignment done but it slipped my mind. So after getting new tires because...