Sponsored

Search results

  1. Edelbrock Stage 2 Water/Meth Nozzle Location?

    Looks like one is a PCV, as it connects to the valve cover.
  2. Edelbrock Stage 2 Water/Meth Nozzle Location?

    Any movement of the TB, it would hit the belt.
  3. Edelbrock Stage 2 Water/Meth Nozzle Location?

    Doesn’t look like mine has it. Both had tubes attached and is closer to the air filter housing than the throttle body.
  4. Edelbrock Stage 2 Water/Meth Nozzle Location?

    Doesn’t fit the 2019 Roush setup
  5. Edelbrock Stage 2 Water/Meth Nozzle Location?

    I am also looking to install meth on my 2019 Roush, but I don’t think snow has the correct injection plate. How are you guys going to install the nozzle? Pictures would help greatly.
  6. Wengerd Performance and Tuning

    If I only have the RTD HP Tuner, how do I datalog?
  7. Question for guys who actually have the the Roush Kit

    mine was a bad relay. Didn’t notice till I installed a gauge to see iat2 temps
  8. Intercooler pump failure, Roush, VMP, GT500 pump.

    Yep, same one I got also. My issue ended up being a bad relay and not the pump.
  9. Question for guys who actually have the the Roush Kit

    Pair Of Power Trim Tilt Relay for Mercury Outboard Motor American Zettler AZ973-1C-12DC4 attached a pic of the one 1 took off
  10. Question for guys who actually have the the Roush Kit

    I ordered the relay from Amazon
  11. Question for guys who actually have the the Roush Kit

    Thanks, found and ordered one. tested the pump at work and it was flowing around 1500 liters per hour. so it either the relay or air in the lines.
  12. Question for guys who actually have the the Roush Kit

    Do you know where the relay is located?
  13. Question for guys who actually have the the Roush Kit

    I got it out and will test it tomorrow. Then look for an upgraded one. If bad my guess it been bad for awhile and just didn’t know. thanks for the help.
  14. Question for guys who actually have the the Roush Kit

    I can put my hand on it with the car running and the intercooler pump is silent and can’t feel it running. I only got 17,000 miles on it
  15. Question for guys who actually have the the Roush Kit

    gauge is setup correctly. Is there a way to check the intercooler pump without taking things apart?
  16. Question for guys who actually have the the Roush Kit

    I will check, I am hoping it just the setup of the gauge is off.
  17. Question for guys who actually have the the Roush Kit

    Thanks, I look at my gauge setup also
  18. Question for guys who actually have the the Roush Kit

    I believe so the GT500 logo shows when it starts. since this a Factory ROUSH, not sure if it’s reading the iat2 sensor right.


Top