In hindsight, I think the "excessive wear" mention was the wear observed on the outside edge relative to the wear across the rest of the tire. It looks like I hammered the outer edge and didn't use much else of the tire. It is my hope to understand if this was a result of the pressures I ran...
This past Sunday I attended my 2nd ever AutoX event after my first event earlier this spring pre-COVID. My first event the car was brand new, bone stock, and I was brand new to driving anything even remotely sporty after a long hiatus from having fun with anything related to autos.
I'm hoping...
I'm curious if anyone makes a dry carbon hood for the 18+. I see Anderson Composites makes dry carbon doors and truck, but I didn't see any mention/listing of a 18+ hood.
Anyone in the know?
I was able to isolate the clicking noise to the bearing by doing just want you did and put the rear of the car on ramps to load rear rear suspension. When I remove all tension load (torque on the fastener) it will stop all clicking noises. I can confirm that. But if any meaningful torque is...
I too immediately realized that and called Dion back. He 100% confirmed that the subframe opening was 1.13"
The total length of each misalignment spacer is 1.28", which includes the smaller OD portion of the spacer that fits inside the ball (0.675"), leaving the 0.51" larger OD portion of the...
Thanks Ian for stopping in. I did reach out to Chris on 7/7 but I have still yet to hear back.
I have returned the Borla system to Summit Racing where it was purchased and they opted to warranty the system out by accepting the return on the item.
Ok.. Just returned home from a week-long backpacking trip and after my previous post where I stated that I only had the binding/bouncy ride issues, I can say that my bearings are now creaking/clicking.
As I mentioned previously, I slightly reduced the clamping load by backing off the front...
I'm going to be the first to raise my hand and say the technical talk of the few posts that follow the one I'm quoting are just a bit outside of what I'm qualified to speak on. :) But I do understand the argument both you and Brian make.
Based solely off what I experienced the other day simply...
Thanks for dropping in! Did your exhaust make it across the pond (safely I hope!) yet? I surely hope the issues Justin and I had were isolated. The fitment wasn't horrible by any means, but after spending that kind of money I would at least expect the tips to align evenly in the rear valance. I...
That was my thought.
Not sure how I could get a measurement on the thickness of the inner ring/ball. Any tips/tricks from the engineer folks? My best guess is a micrometer.
Interesting..
Simply loosening the rear LCA bolt that goes through the BK055 about 1/8 of a turn was all it took to go from "pogo-stick" like ride, to normal. I put about 100 miles on the bearings and the bouncy ride continued until the moment I loosened up on that fastener, the ride improved...
I just finished up my BK055 install and also had a seriously "bouncy" ride. I actually wondered if my suspension was bound up it was so firm feeling.
I'm thankful I came across your above post, as I just performed a similar proceedure to see if it would have any affect on my "bouncy" ride. I...
The BDM is what has the gear ratio programmed, and the BCM feeds the ECU the "data". You can force the issue with the ECU and set it manually (what the tuners do). See below:
Stock 2020 Mustang GT PP1 configuration:
As you can see from above, the tire size and gear ratios are set to "Learn...
Apologies for the "off-topic" nature here, but when did the SuperPro bushings hit the street? Haven't seen much mention of these prior to a few recent posts.