Sponsored

Search results

  1. HOW TO: Add MyFord Touch/Sync 3 to base model S550

    I did the swap this weekend. Everything works great! The only issue I have are some non-critical DST's related to left discharge temps, solar sensors & digital audio control module D. Are there any code changes I can make to remove these? Thanks! Rick

  2. Stereo Information (Wiring, Upgrades, etc...)

    I just noticed/thought of something. The wiring diagrams from the service manual show a CAN bus routed to the factory DSP/Amp. I have heard mention of using forScan to modify the APIM, ACM, etc... but no mention on modifying the DSP. I would think that since it is a DSP that it *MIGHT* have...

  3. Stereo Information (Wiring, Upgrades, etc...)

    That looks really clean, well done sir!

  4. Stereo Information (Wiring, Upgrades, etc...)

    Ya know, I didn't even think about that :) I guess adding the new 3.5" speakers just might require grills... Thanks for the reply

  5. Stereo Information (Wiring, Upgrades, etc...)

    I have been reading this thread for the last few days as time permits. I am a little over 1/2 way thought now. One question that comes to mind, and that I have not seen answered yet is about base model mustangs (in my case a 2016 v6 base model) converting to the factory 12 channel DSP/Amp. On...

  6. Stereo Information (Wiring, Upgrades, etc...)

    Thought I would take a shot at making a conversion harness diagram for those wanting to upgrade from base to factory 9 channel + Factory sub. I found that there are some great deals on eBay for used factory parts. I would appreciate it if someone who has done this could look this over? [edit]...

  7. HOW TO: Add MyFord Touch/Sync 3 to base model S550

    I am guessing that pins 9,10,11,28 & 29 on the APIM connector are used for adding outside audio (analog presumably) signals to the audio system??? Thanks, Rick

  8. HOW TO: Add MyFord Touch/Sync 3 to base model S550

    I made a visual DIY harness diagram to share (attached). This is intended for 2015-2018 base models to sync3. I would really appreciate review/feedback if anyone has time? A question, and observation Question: Could one swap the climate control module from the base model bezel into the...

  9. SYNC 3 swap, It's all in here

    I'll keep my eyes open for that bezel :) I did finally find really nice pin-out/diagram info here on this forum! https://www.mustang6g.com/forums/threads/how-to-add-myford-touch-sync-3-to-base-model-s550.31286/ Thanks for the info! Rick

  10. What snyc3 APIM's support Nav?

    Thank you for the answers! Rick

  11. SYNC 3 swap, It's all in here

    I am having a really hard time reading those images on the very first post. Is there a source for higher res images somewhere? Mainly the important schtuff like pin-outs, etc... Also, I have been scouring the internet looking at bezels. Finding the bezels without seat heating controls is not...

  12. What snyc3 APIM's support Nav?

    New to this forum, and I am trying to piece together a 4.2" to 8" sync3 nav upgrade kit for my 2016 v6 Base model. I saw the 100+ page post about the upgrade, and have read through much of it (time permitting). I did not see anywhere (yet) how to identify a nav vs. non-nav APIM? Is there a part...





Top