Search results

Here is where I am at 400 miles after tune update with adaptions turned on. Have tried above process and a ford cycle pdf the best I could. I will try again tomorrow and if no luck reach out to tuner Monday.

100% sure. I am original owner. All emission systems intact. During the Summer I had the battery disconnected for 5 weeks while I installed parts. Only put less than 500 miles on car since this all began. Then switched tune after first not ready report from emissions and have put 240 on...

Here is the test results. They underlined vehicle is “not ready” to be tested as reported

Thanks- I will give this a try.

Went in for emissions and all systems not ready. Emission place gave me a OBD dongle and said when the light turns green your ready. Said I need to go through a drive cycle until it’s ready. I have put 240 miles on since tune loaded, combo of short trips, medium trips, freeway and surface...

Harness sold. Rear seat delete still for sale. $100 see description in original post. Thanks

Yes I will sell the harness separately. Only used 1 season for HPDE. Purchased in May of 2020 from HMS Motorsports.

Bump

HARNESS SOLD-Selling Schroth Quick Fit Pro Harness with backseat female seatbelt receptacle for a 2015-2017 Mustang. With this receptacle it will fit all S550’s by installing this in your 2018+ model years. Comes with all hardware and instructions. Used for 6 track weekends. Also selling...

Perfect! Thank you for confirming.

Does anyone know the front seat mount bolt torque spec? I have a 2019 PP1 Premium. Just installed Watson Roll bar and re-installing stock non recaro seat on passenger side and fixed back race seat on drivers side. Using Vorshlag seat mount base for driver seat. Would torque be same for the...

Installed once and removed a week later as I got a Watson Roll cage and went a different direction. New these are $59.95 on Amazon. Asking $40 or best offer.

Did this mod exactly as OP did and the improvement in sound is as stated by OP. Now I can actually turn it up. Cleans up the sound. Thanks.

Yes Zero_Chance is the real deal. Installed my Vortech Kit and OPG/CS almost 2 years ago and it has been flawless.

Stripped flare nut need to replace. Anyone know the diameter or the hard brake line? 2019 Mustang GT PP1. Any help is greatly appreciated.

I got bored and added a Vortech V3 package from Beefcake during the lockdowns. I also did OPG/CS. I have done suspension, chassis, brake cooling, hood vents and opened up front grill. I bought the kit changed the include 3.6 pulley to a 3.8 and tuned on 91. I asked for a conservative tune...

Do you give incentives on F250 Diesels to tow our awesome Mustangs to the track?

Thanks. I took them off and will look into the drakes.

Installing Steeda End Links and when I turn wheel end to end it makes contact with strut. I won’t turn it all the way because it looks like it will snap service nipple off. Does anyone know if this is a compatibility issue with my setup? I have Steeda Control Arms, lateral arms, bump steer...

I just called MMR and this is for cars with sensor, you will not need to buy cover. They also have an option for a billet cover but they said that is a couple of months out. That option will have heat sinks to further increase cooler.