Sponsored

Search results

Search the forum Search Articles

  1. Indiana 20" foundry wheels x3

    Three of the stock 20" foundry wheels from my 16 gt premium. The fourth wheel is bent which is why I replaced them. Wheels only...no rubber. There is no curb rash on them at all. They are very dirty because of road conditions when I hauled them in on the trailer to the tire shop to get...

  2. Odd tail light issue

    I had noticed a long while back that the outside bar on my left tail light was brighter than the others with the parking lights on. I didn't think much about it though. Then the other day I was following behind with a buddy driving the car and saw that the turn signal is not right either. The...

  3. Flow One F2 wheels ordered

    I was looking around on Tire Rack website and found they had discounted some of their Flow One wheels. They are F2 in gloss graphite, size is 20x10 et 40 and they show as rear only. After a little looking here and I feel like it should be just fine for a squared set up. I've got some fairly new...

  4. Finally got my Kimber

    I've been saving points on the credit card for 5 years and finally brought home my Kimber. Stainless Raptor II...full size and absolutely beautiful. Damn near too pretty to shoot. It's probably going to stay mostly a safe queen, but I'm sure I will get the itch to warm the barrel up now and...

  5. Check engine light after header install

    I installed a set of 2M Fab catless long tube headers a while back. It had a Steeda tune right away. After a few miles I got the CEL to pop on. I checked the code and it was P2096, which is lean bank. Contacted tuner and was advised to check for exhaust leak. Sure enough, there was a pretty...

  6. One more too loud after long tube headers thread

    16 GT...had Corsa extreme catback on it when I bought it. I really liked the sound....but then I needed headers...Lol. I just installed some catless long tubes...and I knew it was going to be louder but damn. I've searched and the majority say adding some resonators should tone it down some...

  7. My Mach 1 tribute car

    I got this 16 GT premium and I really wanted to do a 70 look, but I couldn't figure out how to mimic the rocker panels. So I decided to use the reflective 69 stripes. I will say that it didn't turn out quite like I was hoping for, but I am still happy with it and I believe it still gets the...


Top