Search results

I have a 2019 PP1 with the 3.55 iron pumpkin that includes a diff temp sensor. I just picked up a low-mileage 3.15 aluminum pumpkin also from a 2019. The rear cover has the threaded port for the temp sensor but without any sensor installed. My real question is, does the sensor go all the way...

I need to switch to a 3.15 gear to prevent going into 7th gear on my 10R80 on 1/4 mile runs. I run a 305/45/17 ET Street R and do not want to swap to taller tires. I started looking for some 3.15 pumpkins out there on the marketplace but before I do that, I wanted some opinions from others who...

.

SOLD

Installing a new carbon steering wheel that retains the heated steering wheel function in my 2019. The steering wheel did not come with any instructions on which wires to tap into for power/ground under the airbag. Hoping someone had either the correct wire colors handy or even the wiring...

Gathering all the parts necessary for Stage 2 Comp Cam / OPG / CS install on my 2019. ARP has a part number for both 6pt and 12pt version of the same cam tower bolts, with the 6pt being about $10 cheaper. Is it necessary to use a 12pt in this application for clearance purposes or is the 6pt fine?

SOLD

SOLD

Question for the exhaust guru's in here. I currently have Kooks Longtubes connecting to the Ford Performance Extreme catback using the Kooks factory-sized connector pipes. Kooks sells the full 3inch connector pipes so that is not an issue. My concern is the Borla 3inch catback comes with a...

I have searched this topic on Google and it led me to some Ford Truck websites where they were able to designate which lights were the DRL and then keep them at full brightness at all times, regardless if the headlights are on or not. I was wondering if anyone has tried this on the Mustang or if...

Thanks to COVID, I been working from home and bored. Ended up ordering, waiting for shipment, and installing the following: Ported Cobra Jet manifold (Bret Barber/AFS) VMP 137 Monoblade throttle body Steeda CJ Closed CAI S&B valve cover breathers (keeping my existing JLT catch cans on hot...

SOLD.

SOLD.

SOLD.

SOLD.

Sold.

I guess I am one of the few that has no issues with the stock Ford oil drain plug. I had been reusing the plug that came with my car and decided to Amazon order a new plug for my oil change last night and was pleasantly surprised that Ford updated the plug by removing the center tab and...

QA1 Carbon. Looks good and is substantially less weight than the stock driveshaft. Waiting on new bolts to arrive before installing. Hope it's up to the task of launching off the transbrake next month!!! (Already have GForce Renegade axles installed)

Now that my longtubes are installed, I am preparing to place my order for a ported Cobra Jet intake and the other required parts. I currently run JLT catch cans on both sides and no issues with that other than I would like to go with valve cover breathers (similar to the below picture) when I am...

Finally, started installing (on my back) Kooks off-road longtubes that I purchased on Black Friday. I am not in any hurry since the drag strip does not open back up until March and this is not a daily driver but I am hoping to finish up this weekend. I was leery of jacking the car up high enough...