Looking for what each wire is for the performance pack gauges. Putting in an aftermarket boost and oil pressure gauges and need to know which is power ground etc etc so I can hook up my new ones. Any help is appreciated!
Just had p2196 and p2198 come on. Have had the whipple on for about a month now and been driving fine. Checked for air leaks after the MAF, good there. Removed my boost a pump, didnāt change. Checked the charts for the sensor voltages and from what I can tell they are changing per afr. Noticed...
Yup, thanks guys. Without ac on or heat, ect went up to 185 then the thermostat opened, dropped to 175 and was rising which is normal. Turned on ac so the fans would come on, dropped to 175 and was very stable. Win! š
If I'm sitting at idle with the ac off no, I know it's going to warm up until the fans kick in. But with the ac on or cruising with flow through the radiator? It's hotter than the factory thermostat.
I've done every possible test I can think of, even threw vacuum at the cooling system thinking I have a massive air bubble behind the thermostat, no changes. I will order the Reisch and give it a try.
Hmm. I can understand that. I just measured with an infrared thermometer while the ect was around 195. Upper hose is about 165 and the lower hose is around 95.
I did get a Murray thermostat from work and it is another motorad š
Been having an issue with the thermostat. While driving at cruise it will steadily increase until I donāt feel comfortable and will downshift and lift. During deceleration it will plummet 10-15 degrees, then as I resume it will slowly increase again. Itās the 160 thermostat, Iāve done probably...
I have the fan upgrade. I understand wiring. Simply was asking if they sent me the wrong harness which I believe they did not. Sorry I did not include all the needed info in my first post. After looking towards the back of the manual, it seems the single red wire with connector goes to the fans...
So I found this diagram searching, thinking they updated the design but no mention of it in the manual yet. I take it by this diagram the ic pump gets power from another source?
So Iām having a hell of a time getting that last 10mm bolt on the oil pump pickup tube. Any tips? Canāt get my fingers down there to spin it by hand and my ratcheting wrench doesnāt have enough tension to click back. You think I could loosen up the oil pan so the front drops down a little so I...
Selling some things I have leftover from when I had the Ecoboost. Both of these are new never opened.
McLeod Ceramic Clutch Disk - $175
https://www.ebay.com/itm/164257934493
Fidanza Billet Aluminum Flywheel - $325
https://www.ebay.com/itm/164257956468
I'll sell them both at $500 shipped...