Hi All,
Currently only suspension mods I have on the car is the Steeda IRS Base pack, however I am looking to get some springs and shocks to hopefully remedy the lack of precision from the front and the floaty back end. However, I do not want it to be harsh or jarring. I have a Fiesta ST for...
I have a feeling that one on ebay has been on there for ages, probably because of asking £950 for it!! 😂 You would not be able to use the actuators from is as they are PWM controlled, which the controller wouldn't be able to utilise. I did consider trying to use my OEM actuators, however I...
I haven't done a writeup but they were dead easy to set up. Literally just have it plugged into the power outlet under the armrest, cable then is just tucked under the carpet, under the rear seats into the boot. The controller box is just mounted in the spare wheel well and then the two cables...
I managed to fit an active exhaust to mine all in for under £600 using a OEM 2018 exhaust as I wanted the quad tip look but didn't want to spend a fortune at the time on the Ford Performance GT350 Active kit that was £3k+
This is how I did it:
-Found a used 2018+ OEM exhaust, in my case it was...
Out of interest how much did Stackry save over using shipping from Tasca?
Thinking of getting some GT350R sway bars and spring but shipping from places like Levittown is looking like $1000 😲 Tasca shipping is around $200
Another thing to note about a pre 2017 car is that the road tax is just over 3x more expensive than a 2017-2018 car. When I bought mine that was a major consideration as was getting sync 3 as I wanted android auto. According to total car check road tax on the vehicle you linked is £695. A 2017...
Wheels look mega. Regarding the tyres, have a look at Asda Tyres, i don't think they have the rear sizes but the fronts are £20 a tyre cheaper than blackcircles fitted, plus they also are offering some asda vouchers for buying Michelin tyres, makes the weekly shop a bit cheaper if nothing else...
Sounds like a good combo, I run the switchfire on my Pre-facelift with bullitt active axle backs which is great. A mate of mine has just put S-Types with a H pipe on his, so definitely interested to see what the difference is like when you combine the switchfire and S-Types, do you have any videos?
Just had a quote back at £648 for Ford Protect Gold with £250 excess, must have upped it a fair amount recently unless there's differences between 15-17 warranty and 18+, perhaps oil cooler related?
Was considering it but not sure if they would warrant it with mods, would assume not.
I've got halfords plates, they are fine and bend enough only down side is the razor sharp edges! At the moment mines just screwed in but its starting to bug me. Could always try magnetic plate with the magnets fitted behind the bumper
No worries, glad I could help! It is a bit tight to the painted part of the valance but theres enough clearance that is doesn't get hot. Ran it like this for about 2/3months and its been fine. I will probably make a thread at some point for 15-17 owners wanting to go quads as the information is...
As promised pictures below. I cut a bit too much away from the outside of the tips, but when i was doing it I kind of made up my mind that it would only be temporary until I decided/found a diffuser I liked hence the edge trim tape that isn't straight! :crackup: Again, this is a unmodified 2018...
I found out the same when I fitted a '18 Bullitt catback to my '17. Like yourself I wondered why everyone else managed to work out ok and didn't have to trimmed the painted section. Turns out most either adjusted the hangers or only used the axleback part meaning they had more flexibly over the...
Welcome! Nice to have another mustang in Warwickshire.:rockon: I almost got my roof wrapped at ReddiWarps in Redditch but changed my mind and wanted to keep the roof blue. Might be worth getting a quote from them, I know they have worked on a few mustangs before. My friend had a Toyota GT86...
Are you running full 2018 catback, if so did you have to mod it at all to get it to fit the 350 diffuser? I was under the impression that they didn't line up. Don't suppose you have some more pictures of it? I put the 2018 catback on mine but just cut the rear diffuser but i'd rather have...