Search results

I had previously posted recommending the Bendpak 4 post HD-9 since that I what I have and it works great. I don't have the trolly jack for it but I have the platform. Regardless, trying to raise a wheel to do brake work on a 4 post is a pain without the expensive trolly jack. I saw another...

Sending PM. I'll take the spacers.

+1. I have the HD-9 (not the wide) and I decided it was worth the extra $1k, or so, to go with Bendpak over the cheaper alternatives. Prior to this I had a Bendpak midrise lift that was old, reliable and required little maintenance. I put it up myself (with some assistance with heavier...

I think touchup paint will make it look better, but no way to get it back to 100% without a respray (at least in my opinion) and probably not worth given that doesn't look too bad and you have white car, which will make the touchup less noticeable. I've used Dr. Colorchip on two of my cars...

Interested. Just sent PM.

My local ford dealer referred me to a local performance shop and told me they charge $500 and that includes a dyno. I don't want the dyno for this type of upgrade and I'm not paying $500 for that job. If I was throwing on a procharger..... I'd want the dyno. I spoke with my local independent...

I'm probably not the best person to point to bars and nightlife, but the Sprint Arena and Power & Light District (same area) are good bars and places to eat. It is a fun part of downtown to check out and you can take the free rail cars between Crown Center and and River market, which is on the...

I'm in the Kansas City Area. For shopping, I would recommend the Plaza (country club plaza) which is about 10 minute drive south of downtown. I would also recommend Town Center (in Leawood) and Zona Rosa (north of downtown). The Plaza is the higher end shopping and plenty of great places to...

Paul - thanks so much for the pictures. This was very helpful. I am going to send you a PM to discuss further. Thanks.

Does anyone have good pictures of an S550 sitting on 19x9.5 +39 wheel setup (squared). I've seen one picture of 19x9.5 R and 19x9 F, but haven't seen a square set up yet for 19" diameter wheels. Any pictures would be appreciated and if anyone can confirm the +39 is a good offset for S550...

I've been going through a similar decision point with a lightly used stock 2016 GT PP that I recently purchased. I was planning on doing SC and may still, but I decided to keep warranty in tact for a bit longer, ensure car does OK, get familiar with it, etc. before investing too much $$$. I...