Search results

Thank you, initially i wanted lighting blue with white stripes, but i ended up with race red stripe delete. Trying to decide if i want to add gray with black stripes from big worm.

My garage, nothing special, but the Shelby is special to me. Love the big red beast!

Looks great! Probably do need to add lowering springs if you go with 30s. How's the ride with those springs? Is it harsh?

How is your wheel gap with 30s vs 35s? Is it noticeable?

Can you please provide pics? I'm looking at doing this as well, but concerned about wheel gap. Would the speedometer be off or not enough to matter?

My picture wasn't the best. This area is the bottom side of the muffler.

Here are some pics of mine. I couldn't really get a good enough pick to see a hole, but man the soot! My car does burn a quart of oil in 1500 miles.

Thanks, :headbonk:

I searched the forum and didn't see this issue. I just noticed a small hole in the weld of both mufflers. I noticed small amount of carbon on my garage and decided to put my hand near the muffler to see if I could feel any leaks while the car was running. Sure enough, I can feel exhaust...

Thanks for the feedback. I can drive mine for 15 minutes and it looks like this. I think this is a sign of considerable amount of future oil consumption. I think the "carbon splat" look is from condensation mixed with carbon, not 100% sure. Wondering if there is a correlation between high...

Those with high oil consumption, do you have "carbon splats" on your exhaust tips? I'm not talking about a dry powder look, I'm talking about a black splat look. (I can upload pics later) It's mainly on the inner exhaust tip not the outside tip as much and I drive with the valves open. I...

I'm going to try it, if I don't like it I'll take it off. To each his own when modifying your car. It's a plastic part adding Plasti dip....well... look like a plastic part. Lol

After watching Plasti dip videos, I'm going to attempt to Plasti dip the harness slots. If I don't like it I can simply remove it.

Does anyone know how to remove the harness slots? I would like to paint or Plasti dip mine.

Thanks guys!

Do you to remove the wheels to replace the center wheel caps on the non R? Is there a retaining ring holding them on or are they held on by snap fit?

Does anyone know dyno results on 260GT fuel?

I found ethanol free gas station near me, (only one station) it's rated at 90 octane. Is that better than 93 octane with ethanol? Thanks for the link!

I completely agree!!