Hi, I would like a little more information on sai li fuel system. I am looking for a system that uses mostly steel braided line for the complete system, does this sai li kit utilize the factory supply line then steel braided for the return, or does the kit adapt the factory quick connect to AN line?
I was wondering if you would be willing to help out with sourcing some connectors, i am adding the my color ambient light sources like the door sill plates and footwell lighting and im have a bit of a hard time finding the correct connectors for these. I would like to make a harness for my car...
I heard the same thing but i do not believe this because if you look at the sync 3 version 2.2 updates the non nav is actually a larger file then the nav file. I have also turned the nav icon on with the as built data already,
Did you add navigation to a non nav unit with as built data, i have done this on a sync 2 unit with success and i have attempted this on sync 3 but could not complete it because i needed the navigation file. I would just like to know of anyone who has successfully done this to a sync 3
I have and even got nav to show up but i didnt go any further because i didnt have the sync 3 update with nav to install for the maps, i did however enable nav on sync 2 and everything functioned
the front port should work as long as you plug it directly to the apim. I could be wrong on this but i believe the people who are saying the dual hub will disable the front port is because it only has one connection on the back of the hub unlike the single port that acts as a pass through for...
If you run a single port you do not need to run a cable to the front as long as you plug the original front cable into the sync 3 apim. Be carefull to check the proper location for the usb cable for the apple car play module as there is only one port on the apim that allows for the sync to...
There isnt any connectors on the base model. When you pull it apart it is just a face plate that the usb cable sits in. The usb that you are plugging into is actually the cable the runs up to the apim, it is not a module. If you would like i can post a picture tommorow of the faceplate to give...
I used these at the apim to connect to the factory usb wires and they plugged into the apim YCS Basics Black 6 Inch USB 2.0 USB Mini B Male to USB Mini B Female Cable https://www.amazon.com/dp/B00B5HSA3Q/ref=cm_sw_r_cp_apip_HNxusoZQOImvD
And i used one like this i bought from office depot for...
you can not get the brackets seperatley, ford does not sell them. Youre best bet is to find a cheap damaged sync2/ sync3 unit unless you get lucky and can find someone selling them used on ebay or something
I had the same issues with my conversion and i also have a cheap ebay gps antenna. I did all the same things as you. What i found to have worked was doing a master reset and then Just leaving it alone. It took about four days before it stopped acting up. I think it goes through a learning phase...