Search results

Mine just started doing this also, did you find out what was causing it since the motor was replaced?

Looking to buy an air intake tube and box off a 2018+ GT. Local only in Louisiana or east Texas.

Wanted to avoid shipping fees with one local , but PM me a price shipped. Also I just need the lower box not the lid or tube.

Looking for a stock air intake Box, prefer local in Louisiana first to avoid shipping.

Guess I didn't win ,had my order ready! lol :(

I did a lot of searching here and couldn't seem to find anything on my issue I'm having. I recently started noticing that at high rpms (6k+) my clutch pedal gets a lot harder to press down. I've put over 30k miles on my car and never noticed this before until recently so I have no idea what...

Done!

Bump for price drop.

Sold.

Bump.

Selling my performance pack 15" rotors. They were taken off my 2015 GT with about 38,000 miles. They are in great condition and had no issues while they were on, just went with a different setup. Asking $100 OBO for both rotors only. UPDATE: Calipers are sold, rotors are still available if...

What did you use to seal up the plug you left dangling? Looking for ideas on how to seal mine up once I install without cutting them off.

I see a few people have them installed, so what's the word on vacuum hose size?

Which actuator is damaged on yours? I bought a full set to replace mine but the one with the plug on top is still in perfect condition.

Got it all off. Now to repackage it to send off get ported. Thanks for the help guys. :cheers:

Well got the clips off,went flying across the room but it's off lol. Now the plug mounted on top of the manifold, the one that has two hoses going to it, do I remove that whole plug or just cap off the hose ports below it?

They are the reason I'm removing them lol. I got a new set from someone that installed on a 11-14, so he didn't need them.

What's the best way to remove that clip? Didn't think it came off, and I don't want to break it.

Anyone have advice on removing the imrc actuators? I removed the 3 screws holding each one but can't get it to come off.

I've seen a few post about installs and some say 3/8 vacuum lines and some say 1/2. Anyone have an idea which is the correct size needed?