Search results

Wouldnt know without test fitting but will probably be good in the rear. Are u running stock springs? If so I would bet you are good for play in the rear

Look very similar indeed. Looks like they will be offering the 10.5" width soon it says with 5-25 mm offset. Look closely at the offsets if planning on a different width wheel. Shouldnt really matter however different manufacturers can vary slightly. Also ask if they will square off your...

Damn that sucks. There. Similar designs that with the right offset would look just as good im sure. Sve makes a simar design and cost is same range. BBS would be great but they are pricey

If you have the PP w/ brembos you will need a minimum 8mm (5/16) spacer to clear the front brakes. Not needed for rears. 305/35 will rub a bit depending on your ride height. I rub when hitting dips on the interstate but only minor in the wheel well and i have 285/30. 305 might have fender...

Looking good man!

I had factory replicas but I couldnt pull the weight specs from their site. No doubt they are close in weight to the factory wheels.

Yes they are heavy I suppose. From what I can tell they ride very smooth and I honestly cant tell a difference between these XXRs and they were much lighter. I did change from stock height to BC racing br type coilovers when I put the XXRs on and the car does handle different. Your setup or...

Not sure about 305/35 in the back. Not saying no but depends i guess. Are you stock height? Springs? Coils?

Shot of the bumper from I5autohaus. I follow this guy on instagram. Some of the pics are pre/post hood. I5 also sells the splitter for this configured S550/GT350 bumper if desired. Splitter is priced a little high imo.

Yes sir

Thats what im guessing. I learned about mp concepts after purchasing my bumper last week. I did choose the prepainted option in black so we will see what the quality is when it arrives, hopefully this week.

I didnt mean the splitter, I meant the grille extenders I guess... whatever the hell they are called lol. They are just above the splitter and angle down and aft and split up at the end like an upward fin just below the turn signal

That is correct, from what I can tell and customer photos it does not have the 3 piece splitter. Also, the outside area of the splitter on the MP Concepts GT350 bumper (just forward of the tire) has a more upright angle to it, whereas the one with the 3 piece splitter rounds off and goes up.

I5autohaus and mpcustoms has one that is slightly different and there are a lot of good pics through i5autohaus. The lines and angles are a lot different than the one from ikon. I ordered mine through i5 a few days ago. Ill post pics once i get it so you guys can see.

Thanks man and yeah im about -1 on the front

Thanks man, I got the from late model restoration

and the last ones.. i know i'm obssessed...

A few more shots now that I've wiped her down... kinda. Tried to get several angles for you guys that have been asking questions. I also snapped some shots of the tire poke out from under the fender. Took these with a Note 8 so not the best quality but still turned out. It looks so much...

I did have an alignment done but adjusted my front camber to between 0 and -1 on both sides. Dude said it was spot on and with the height there is no rubbing. I'm running on BC Racing coilovers mane

Pictures honestly do not do these wheels justice. I've been in my garage for hours just walking around the car lol