Search results

Figured I would come here first. 3-4k rpm only and under medium to heavy throttle under load. Does not do it stationary and reving nor does it do it on a slow rev up to 4k while driving. Only when i get into it. My gut is telling me tensioners that i already had replaced at 19k miles. Car...

Evening fellas and ladies, i have a 16 Gt with 65k miles. I had the front main seal replaced around 19k due to an oil leak around harmonic balancer. Well last week i went and got an oil change and noticed after several days the oil smell with the heater on wouldn't dissapate. Found the...

I had a compression test and leak down test done on my engine in prep for a whipple install. Here are my readings on a 16' with 62k miles. Compression. Leak down 1. 215psi 1. 2% 2. 210psi. 2. 0% 3. 200psi. 3. 0% 4. 220 psi. 4. 10% 5. 220 psi...

I recently replaced the left rear wheel hub due to the popping/metal pinging sounds. Not to bad of a job. Did it without removing suspension. 4 hub bolts were a bit difficult. What is this black shaving all over the oem bearing? Spun fine, no noise or play. Thrust washer was worked.

I am having a dyno test done tomorrow morning and not sure what to expect. I am wanting to see if I'm in the ballpark for what a stock engine should be. basically if the engine is healthy. I suspect there is something off cause it feels down on power. He mentioned welding in a bung for air...

Been having detonation issues after installing the FRPP2 kit a couple months back. Plugged in my scan tool and saw that my STFT and LTFT are both positive at 3 and 8%. The stft2 and ltft2 are around the same. I have checked for vacuum leaks over and over minus taking it in for a smoke test...

I have had this kit in my garage for over 3+ years. First original group buy Dec 16'. Had a plethora of problems so shelved it. I am finally ready to install this kit. I have a couple questions. Can I or should I install tune onto vehicle prior to installing hard parts and CUTTING vacuum...

I have been having this pop sound ( sounds like when you run over a sharp rock or puncture a tire) every time I start to reverse the car. It sounds like its coming from the driver side rear. I have checked the hub nuts and manhandled the wheel to check bearings and seems good. It does not...

So I haven't given much thought to this and then started wondering if this correlates to my 1500 rpms clutch pedal vibes during disengagement. With the parking brake off on a flat surface and the car running if I press the clutch to the floor and shift to first the car will slightly creep...

Had my stock clutch replaced by the dealer 10k miles ago because they said it had half life left when they replaced the tranny. Cost me $520 and have had a bad clutch pedal vibration at 1500 rpm ever since. They stated it was normal. Now the clutch is starting to get heavy and slipping a...

$135 to program bcm. Didn't work. Middle tri bar stuck in brake light mode. Need a replacement.

I have had a plethora of problems with this car over my 3 years of ownership. Two weeks ago I took my car in to have a leak looked at around the Harmonic damper and lower timing chain cover. They said it was a bad water pump and replaced it. Last night I popped the hood and found the damper...

Decided to do an engine check tonight and found oil inside my harmonic balancer pulley. Upon further inspection there is oil on my sway bar and lower plastic engine guard. I grabbed a flashlight and saw what looks like fresh oil behind the crank pulley up against the timing chain covers...

I have been suspect of either a vacuum leak or a partially clogged cat. At idle my vacuum is at 19.2 and pretty steady. When I punch the throttle in neutral the gauge drops immediately to 0 and then jumps to 22hg. Flooring it in second gear, the gauge drops to 0 hg and stays there for the...

$4.79 for 91.... 10 refineries and 6 are down for maint/issues. On July 1st, the gas tax increases another $.06 a gallon. They predict this will continue through summer. They predict $5 for premium within a few weeks. Time to ride the bike to work. Luckily I live four miles away. Feel...

I had my clutch, flywheel , tranny replaced about five months ago or 5000 miles. I have this weird vibration that can be seen/felt through car in neutral ( manual) when I slowly rev the car up to 1500 rpms. There is no vibrations before that or after that it smooth's out. When I push the...

I have been trying to understand why my car just feels neutered. I bought a scan tool and went to work. Mind you no check engine lights or Codes found. My short term fuel trim is at +3 and my long term fuel trim is at -3.4. According to research means over time I have been running...

Dealer will be replacing my throw out bearing and pilot bearing due to excessive noise and vibration. I still feel it is my input shaft bearing due to the nature of the sound and when it happens. He said he will inspect my clutch and flywheel for abnormal wear but did not say if they would...

Check engine light came on last night leaving work. Car started fine drove ok to my brothers and found crankshaft position variance error code. Car is stock minus axleback. Dealership wont be open until this Tuesday. Safe to drive?

I have this high pitch whirring sound at idle in neutral. Sometimes it rattles. Push in the clutch and it goes away. When I accelerate in 1-3 I have this whine sound that increases pitch as rpms climb. Sounds like a miniature supercharger. Car shifts ok besides the notchyness but it feels...