Well, you might find this funny. But I've only installed the drivers side one. I had HELL getting the ball joints lose. So with how long that took, I haven't had enough time or really willingness to tackle the other side. hahaha.
Now this is just a weekend car so I maybe put 200 miles on it...
I installed some new front lower control arms with the Cortex solid bearings
Well my driver side one is turned sideways. Is this normal with these bearings?
I am also hearing clunking noise not really going over bumps but more when driving on uneven roads that are not smooth.
I think it is the...
GT500 injectors will fit Gen2 15-17?
Why does CJ pony say they wont?
https://www.cjponyparts.com/ford-performance-fuel-injectors-55lb-hr-ev14-uscar-set-of-8-mustang-gt500-2020-2022/p/M9593M55GT/
Wow, I'm so happy I found this thread.
I've been wanting to do the manifold swap for a very long time but I love my painted engine cover and the 18+ is ugly.
Few questions.
1. So all you dremeled was all the way to those holes and the mount for the imrc stuff?
Probably got to be careful and...
Ahh Yeah mine doesn't have that divot.
But I can see what you are talking about. That would make more secure on the stud.
Might end up drilling it. Thanks
See, I saw that little ball on the tool end and figured that goes into the stud end but I already beat the stud so much that the divot on the stud was gone. lol
I understand now putting tension on it when hitting it helps. Will try that on the passenger side.
Yes, finally got the front driver side one off. Going to work on the passenger side tomorrow.
My neighbor suggested a torch. So borrowed a friends at work.
But I first used that tool which was posted on the first page but it just kept slipping off the bottom of the stud even with the nut on...
I appreciate the help.
Does this look like the same took as the CTA one?
https://www.amazon.com/Sporacingrts-Separator-Removal-Adjustable-Extending/dp/B0CBPN18MG/ref=cm_cr_arp_d_product_top?ie=UTF8#customerReviews
Yeah, I hit the rod end a few times and hasn't much if any. Of course it's hard to get enough power hitting upwards on jack stands.
I only have 20K and the car as been in the south. There is some rust but nothing like you would see up north.
Ok, I am going to order it thanks.
My neighbor said to use a torch to heat up the knuckle and then whack it a few times, but rather use this tool. My arm is tired. hahaah
I am having hell trying to get the forward control arm off. I've beat the knuckle tired to use a front end kit from harbor freight. The one on the top right worked for the rear arm but I can't get a good angle for the front arm. There's nothing to attach one of the legs too.
It will not pop...
So will that tool fit on the forward control arm. The one with the air deflector?
There's room for it?
I am having hell trying to get mine off. I've beat the knuckle tired to use a front end kit from harbor freight. The one on the top right worked for the rear arm but I can't get a good angle...