Last summer I bought an A2W setup to run in place of the Vortech A2A intercooler. It picked up a few psi and IATs were stellar. I have since pulled the blower and the car is just N/A.
PNR 7 gallon trunk mounted ice tank
16AN fittings welded on tank, 16AN fittings in the intercooler too
1 inch...
I have a set of blizzak LM32 275/40/19 tires that were on my car when I bought it. 2 tires have 9/32nds and the other 2 have 6.5/32nds. I live in Texas so no need for them. I’m asking $500 shipped for all 4.
you mean like a UPR turbo kit?
Honestly i think the CG Fabrication hotside setup is about as cost effective as it gets while still allowing you to go "custom"
while my tastes are along the same lines as gimmie11s, I'm really glad someone did a CG fab single coyote kit on an s550 AND made a thread with pics! One question though, how much room is there for a larger downpipe with the factory cooling fans? Definitely in to see you guys make the 7675 do...
I second this motion. When i had my S197 car it had the mt82. On a Hoosier slick when NA i would two step it at 6500, get a smidge of spin, yank the front tires off the ground and put consistent 1.59-1.61 60' times. Then I went turbo and around 4500rpm with about 16psi of tire pressure on the...
the 66mm turbine i believe is way too small. it might make 600hp but will not hold it in the upper rpm range. precision makes a 67/76 and 70/75 in a t4 setup. these will at least hold that low 600 number to redline IMO. for lag i would focus on the hot side piping, small and short. Im not...
Hey bud I have a few questions about the wiring for using a gt350 dual pump setup in the roadheaver kit.
I am assuming a second FPCM module is used to drive the second pump?
A GT350 runs two FPCM modules. On a GT350 wiring diagram from Ford it shows 1 yellow/orange FPC(command) wire from the...
As for Houston dealers, im getting my base 15 gt auto w/recaros from autonation katy. msrp is 36,010. price before incentives is 32,431 (internet price, bout 800 under invoice) and after incentives im at 30,681 plus tt&l
dealer trades are not ideal in my opinion, more work on their end and the trade they give may not be one they wanna split with. find the dealer with your car and deal with them directly. if your local dealer wont divulge the dealer that your car is at you can at least get the vin (asking for a...