Sponsored

Search results

Search the forum Search Articles

  1. 🏁 Official: 2025 Mustang GTD Revealed! 800+ HP, Pushrod Suspension, $300K MSRP

    Lots of rumors - Will this be like the FORD GT where it is only offered direct from ford through lottery type submissions? no doubt these will be sold way over msrp by most of the greedy dealers out there.
  2.

    Utah NEW Set of 4 MICHELIN PILOT SPORT CUP 2

    ... and they are out of stock as well when I just checked on TireRack
  3.

    Utah NEW Set of 4 MICHELIN PILOT SPORT CUP 2

    I ended up with an extra new set of MICHELIN PILOT SPORT CUP 2 tires. Never used, never mounted. 2 - 305/30ZR19 2 - 315/30ZR19 Locol a pickup in Salt Lake City - $1650 for set of 4 and happy to Ship for + $125 as shown

  4. Voodoo Swap In My 63.5 Falcon, almost done

  5. Voodoo Swap In My 63.5 Falcon, almost done

    Can they? I would say this may be the best engineered street/road course built falcon around. You can see a lot of the build here https://www.facebook.com/RDspeedgarage and this article ,... GoodGuys Fuel Curve / Voodoo Falcon

  6. Voodoo Swap In My 63.5 Falcon, almost done

    Here is the latest Teaser clip driving the Voodoo Falcon ((( SOUND )))

  7. Voodoo Swap In My 63.5 Falcon, almost done

    here is a little teaser clip of the VooDoo Falcon! (((( SOUND )))) Voodoo Falcon teaser

  8. Going to limp mode at 6300 rpm

    They are the ones building the map... just not seeing what is triggering it for some reason? maybe bad throttle body?

  9. Going to limp mode at 6300 rpm

    Thanks - it’s a 2016 Motor / Trans with a full Haltec ecu& harness - no sensor in trans or diff - extra oil abs trans cooler + accusump - note this motor is not in the GT350… it’s in this falcon

  10. Going to limp mode at 6300 rpm

    We are doing some tuning and for some reason the motor goes to dead pedal limp mode when we go over 6500 rpm? the map does not show anything wrong? air/fuel, oil temp and pressure, trans, etc all good temps and pressure.. water temp at 190 -

  11. GT350/R Engine Build Date codes

    Is this a gen 2 ?

  12. Is this a GEN 2

    I am looking to buy and not sure if this is a gen 1 or two motor

  13. Voodoo Swap In My 63.5 Falcon, almost done

    Here are a few older shots during our build

  14. Voodoo Swap In My 63.5 Falcon, almost done

    There was a ton of work on the suspension and chassis. The front is completely custom engineered with nothing off the shelf. we are about 3+" wider track, had to put a full new floor in ( GT350 floor) to fit trans and other, widened rear panel /tubbed, etc.) We retained the stock header &...

  15. Voodoo Swap In My 63.5 Falcon, almost done

    Will do... we are now in the short test drive at a low rpm stage with building up the ECU mapping once we get to where we feel comfortable, we are off the the dyno for full performance tuning. We have added a lot of safety in regards to oil ( remote oil filter, accusump, oil coolers, larger...

  16. Voodoo Swap In My 63.5 Falcon, almost done

    Waiting on the custom set of Forgeline wheels and we are planing up to 305's on the rear.

  17. Voodoo Swap In My 63.5 Falcon, almost done

    Thanks.. we rolled the dice a bit..

  18. Voodoo Swap In My 63.5 Falcon, almost done

    It should land around 2800-2900lbs - Tricky with all of the cage and suspension mods

  19. Voodoo Swap In My 63.5 Falcon, almost done

    I have a 2019 GT350R and inspired this build It's been a long process but we are getting close to finalizing this build with my 63.5 falcon Voodoo Swap ( along with massive other mods, from cantilever suspension, widening track, widening body panels, metal flares, etc.. ), wheels are temp...

  20. Shelby GT350/R COLORS Compilation

    BEst part is that It has the stripes and roof now, which I like better... but it's still the far less produced No Stripe / No Roof car


Top