Why give up front grip and cause understeer by going with a smaller size up front. The rear grip will overdrive the front. 285's fit up front and are better if your doing a 2 driver car due to they take longer to get hot otherwise stick with 275's imho as the 285's feel a bit numb compared to...
Awesome build thread looks like we have almost the same suspension setup. I have to work on my engine and thinking of doing the magnum xl swap too so I'll be curious to see how it goes with the blower for you
Run 18x11 at all 4 corners with 315/30R18 BFG rivals. Below they can get you the correct offsets to run but you will need APR extended studs
https://maxcyspeedco.com/collections/s550-mustang
Get a good set of coilovers for it. EDIT: errr just saw you have magnaride nvm I'm not sure what...
The 2018 hits 73 in 2nd now with 285/35r19 re71r tires. This is a huge improvement over the 15-17. It improves a lot of the deficiencies of the 15-17. Don't worry about the top of 1st you will not want to ride out that gear much unless you have VERY good throttle control which coming from a...
The 18 is going to have a very distinct advantage over the 15-17. I can tell you from driving one recently I think the 18s will stand a much better chance against the camaro and the bmw nationally. It is part of the game you play in the SCCA there are cars that come along in the stock classes...
Use the nut and back it off until the end of the bolt and then use a big ass hammer and smack it a few times. Also if you can use a jack to release tension on the bolt it helps a ton! Air tools make it easier but you can do it yourself
Drove an 18 GT PP today (STD) and that will easily beat the 15-17 cars with equal drivers. 73mph vs 61mph in 2nd and the suspension is better stock. Just with tires (285 RE71R) on it I couldn't match the time with a 16 that was fully prepped for FS with the same size tires.
The camaro's and m3...
Sent you my info thank you, first time I have any problems with a product you guys make but I understand it is hard to know ever solution for every shock maker.
I suspect that a washer that is half the height of the one included would solve my issue.