Sponsored

Search results

  1. Cylinder head temps - 2015 GT

    I have a 2015 GT that normally tops out about 207-209 degrees for cylinder head temps before it cools down to about 198-199 and today I noticed it get up to 217 in stop and go traffic. Normal or cause for concern? Car was running fine. By the way, I don't think I ever hear the cooling fan...
  2. GT500 with 25k ADM

    https://www.autofairford.com/new/Ford/2020-Ford-Mustang-839f39730a0e0adf0cb7953977f5a4d1.htm?searchDepth=3:3 Autofair in Manchester NH.
  3. Door latch recall - issues

    So I took the GT in for the door latch recall last week. OMG, what a shit show. The dealer managed to put a big scrape in the front bumper somehow, had wind noise afterwards in the driver side window, both door handles on the outside alignment were messed up and a vibration now emanating from...
  4. Jacking Rails - holes don't line up?

    I'm finally trying to install my ultralight jacking rails and the holes don't line up. I did the very front screw and then went to the rear, and the holes are off by a good 4" or so. Is it possible I was sent the wrong rails? The center of the front hole to the center of the rear hole in the...
  5. Kinsmart 1/38 scale Mustang GT

    Picked this badboy up at the grocery store the other day. Found it purely by accident. They had four colors - silver, race red, what appeared to be ruby red, and deep impact blue. It has the wind up rear axle and is 5" long. Love it.
  6. Vermont TY GT350

    If anyone is close by. $13k ADM. http://www.lvford.com/new/Ford/2016-Ford-Mustang-631bac220a0e0ae75e9725fa65631622.htm?searchDepth=1:1
  7. Weatherstrip issue

    Does anyone else's look like this? This is passenger side weatherstrip. I have looked at it, but can't figure out how to fix. It has been like this since day one and always bothered me. Seems like it just doesn't fit right.
  8. Rear plastic panel alignment - can I fix myself?

    Hi everyone, To target one specific body panel issue, is this something I can fix myself? The plastic panel does not align with the tail light, just on the left side. The dealer claims there is no way to fix and a new plastic piece will not fix the issue. I am thinking maybe a metal clip is...
  9. Airaid installed

    Installed the Airaid CAI without tune. Everything went fine except the sound tube delete which I opted for. I could not get the sound tube out of the firewall, so cut it and taped it off for now. Any ideas in how to remove from the firewall. My hands are too big to get back in there and give it...
  10. Is there a how-to on adjusting fog lights up?

    I did a search and found a few mentions of adjusting the fog lights up so they enhance the headlight pattern, but no how-to. I have done this easily on my previous Ford cars, but am stumped how to get to the base of the fog light to adjust it. Does anyone have a how-to on removing things to...
  11. Has anyone removed the hoodliner

    Has anyone removed the hoodliner? Is that a good or bad idea on the S550? Some have said it can get wet from the hoodscoops allowing some water in. I did this on my Contour SVT years ago with no ill effects.
  12. Anyone from New Hampshire?

    There are two of us expecting cars 3/19 or so. I have not seen a 2015 Mustang on the road yet except the 2 I test drove.
  13. Build week 2/23/15

    My dealer says this is my week.


Top