Search results

Has anyone retorqued the spacers after the 5 miles as per the instructions? If so, was it actually needed or did your torque wrench click off with out any extra tightening?

Thanks. Didn't have to grind down the studs. Those wheels have deep pockets that the studs fit into nicely.

Got my spacers installed. Gotta say 120 lb/ft feels light. Before After

Question for those of you who have installed them already, what did you guys torque the spacers to? Will be installing mine today. ..

Got my tracking number.:headbang: ETA Monday 25th.

Went out and bought a new Craftsman 3/4 hp unit and installed it today. Mustang opens and closes it just fine.

I tried just about every variation of button press when I was locked out of my house because the garage door wouldn't open. I'm pretty sure the method in which im pressing the button isn't the issue. Doing some more research it could be the logic board is on its way out.

I press and release. I can have the mustang as close as possible and it still won't open. I turned the LED lights off my camera and the truck was able to open the door (wouldn't open a couple of hours before). Now I can't see anything inside my garage though, night vision needs the led lights to...

Did ford have to do any testing or did they just swap it out without hassle?

I did read about LED bulbs creating interference and on rare occasions fluorescent bulbs also, so I removed the bulbs today with no luck. I put a vivint wireless camera in my garage around the same time I got my mustang..I wonder if the LED lights in that might be causing the issue? I've got...

I've got a Chamberlain 3/4hp garage door that's worked fine up until I programmed my 2015 mustang to it. The issue is the opener wont respond to the commands from the buttons in the visor to open or close the door. This happens with my Mustang, '12 F150, and the remote that came with the opener...

Lowered with CJPP springs and traded the 19" optional wheels for 20" foundry wheels. Now just waiting on the 20mm spacers to arrive from the group buy in the wheel/tire section!

Will the paint on production pieces match better than the one in the photos?

Awesome man thanks. CJ pony has a video up of the install with no torque specs, however, they do mention when installing CC plates to torque the top three nuts to 46 lb ft. Not sure if that applies to just aftermarket cc plates or stock but I'll probably just go with 46lb ft on top. Thanks again!

Looking for torque specs for front strut bolts, bottom and top. Front Sway bar, caliper bolts, rear upper shock, and sub frame bolts.

Got my CJPP springs in. Shooting for install tomorrow but can't find any torque specs to put it back together, can anyone help????:shrug::shrug: