Search results

Yes

Local pick up only in the Tacoma,WA area set of 4 rims, The rims are a 19in by 10in diameter Bolt pattern is 5x114.3mm with a +40 offset All rims are in great condition, no dents or curb scrapes. Rims currently have cup2 tires on them as well, tires have seen some use however but...

Are you running an aftermarket spolior

And will the oem holes be exposed with the mmd v series or will they be covered by it. Also couldn’t you get away with not drilling the extra holes and just use the two oem holes on each side to keep the wing in place

So will additional holes need to be drilled to install the mmd v series on a GT CS

did you all use the fastener pack when you installed it

To get it to the recommenced -1.5 camber specs for this kit was an aftermarket camber arm needed. I see that Steeda makes one.

does this kit add any noise to the ride, I am replacing some eibach coilovers with the FRTP because the Eibach's make so much creeking noises, plus I'm sure this is a better setup for the track anyway.

Are any additional parts required for installation on a baseline GT?