Search results

based on your first photo, perhaps you can determine tge white washer dimensions based on the known dimensions of the roll pin. just slightly ‘wider’ than the pin, thickness based on the photo of tge pin along with an actual measurement ( exact thickness might not be a critical dimension), i...

Also make sure the roll pin is centered in the shaft i forgot to mention, i blamed the aluminum boot hardware but i had interference with the roll pin, a few passes with a file took care of that, based on your statement perhaps i needed only to slightly move it to true center.

if i recall correctly the leather boot ‘hardware’ slips over that and then the knob over that, correct? i replaced my plastic two-piece-glued boot hardware with the one-piece aluminum aftermarket piece. installing the boot assembly involves clicking it to the lower white collar , the lower...

I cannot really see a great difference in the OP’s photo, here is my 2023 ordered GT Race Red, the bumper seems to match the painted metal, but you tell me if you see otherwise. Thanks.

I am not sure that I am seeing the problem in the photo, the clamp bolt does not appear to be the lowest point. That being said and assuming it is an illusion, 1) will moving the threaded clamp or removing the excess bolt length put ‘something else’ in harm’s way, is the ‘sacrificial bolt’...

Are the 2023 5.0 oil pans steel or plastic?

i don’t mind spending the money up front to replace a questionable part, odds are an inferior component is not going to fail in my driveway.

it would be a very nice mirror satisfying my request if outside that dotted line was ‘blind spot’ mirroring.

thanks S550HPP, it’s not the engine that I am thinking-of as much as the accessory parts wherever an inferior material or process was used to save ‘a few cents’, I guess I left ‘reliability’ out of my opening statement, that’s where I am looking for improvement.

I contacted them looking for advice, they suggested the universal F0400, I honestly do not remember if I placed mine ‘upside down’ but they work fine. I thought it would be a problem with them nit being in the traditional upper outside corners, but such is not the case. Here are two photos from...

…or a couple of broom handle clamps on the underside of the trunk lid to capture one tube of the walker, when lifting the trunk lid the walker will rise right in front of you ready to be grabbed www.mcmastercarr.com would have an extensive selection from which to choose good luck with the project

Exactly, why not follow the weight on the filler cap, Motorcraft, after-all, it was specified by the FoMoCo engineers…

If not for the 6speed manual I would not own the car, lots of alternatives across the range of cars, trucks, SUVs…the 6speed manual V8 combination sets the Mustang GT apart from others.

but, hey, could have been worse, you could have swapped wheels pre-scrape. thanks for your response.

How did you not damage the wheel? Perhaps it’s an illusion but the wheel appears to be in a position to also have made contact with the door structure

agreed, same with plastic parts on say a superduty, not bad with a color, horrendous with black. That’s why I suggested the masked color, that will give the semigloss black an intentional appearance, a finished look. Good luck to you whichever way you decide to go, you have to be happy with it.

…or embrace the situation and rat-rod it! just kidding, but seriously, how about paint the hood flat black leaving some strategically-placed masking of the current gloss paint as to have the finished job appear to be a finished job.

Thanks for the link, Skye.

Thanks ICE445, this topic is something I had not even thought about until the original question was posted.

I am not used to vehicles with electric cooling fans, I have never parked my 2023 5.0 and heard the fan still running as I walked away (as I have observed vehicles doing in parking lots). Does the GT not do that or have my cooling needs always been met?