I had very similar results, my car put down 403 / 395. Car was otherwise completely stock including the exhaust. A 2015-2017 car went on the dyno after mine with the loudest exhaust ever and put down upper 360s. He was confused why my quiet car made such great power. 😁
I used to run on a drag pack on my previous mustang. The skinnies up front really impact your braking ability. I had to panic stop once and the tires locked up instantly. Was terrible. I never ran the skinnies on the street after that.
I have GForce Renegade axles waiting to go in with my whipple setup. But I plan to drag race on a bias-ply, so it was a no brainer. For your use case I agree with what others have said, probably not needed.
Talk to Brandon Alsept at BA Motorsports. He used to work at Finish Line Performance I believe. He has a ton of experience with these cars and I’m sure he’s done many whipple installs.
I did all the work on my previous mustang, but for some reason I may leave this whipple install to the...
11/16/20 for me. Don't care on the wait as I don't use the car this time of year anyway. All other mods to support the Whipple have arrived and are sitting in my basement. I'm assuming sometime in February it will show up.
Someone posted earlier this week that they just received their whipple...
There is a clutch switch that will not allow the car to start unless the clutch pedal is down. Is it making any noise in neutral with the engine running? It's possible the clutch material actually came apart as that has been known to happen with the stock setup.
I purchased the LPX twin disc to go with my whipple stage 2 kit.
I spent months agonizing over clutch selection for my project since the wrong clutch can make the car just awful to drive. I talked to many clutch vendors direct and searched to the end of the internet and back for feedback. I...
Right...a dealer is not going to let a vehicle sleep for 8 hours, so they do the reset with the scan tool.
I put an AGM battery in my 2011 5.0 F150 and just let the truck sit overnight for 8+ hours per the manual. Been fine for years.