Search results

  1. California Signature SV602 20 x 11/11.5"

    Is JeanValJean or V8Venom the seller?
  2. California Signature SV602 20 x 11/11.5"

    Do you have any pics of these on a car?
  3. Edelbrock E-Force Troubleshooting Manual

    Those of you with fuel systems, do you have a diagram of how the fuel lines are routed? Are you feeding into the HPFP anf the rails from a Y or something else?
  4. Dept of boost Heat exchanger

    Looks like the "powa" pump
  5. Nebraska UPR Billet Breather Tank

    I'll take it.
  6. Nebraska UPR Billet Breather Tank

    Where in the engine bay does the can mount to, the strut tower, the front near the radiator or somewhere else.
  7. Nebraska UPR Billet Breather Tank

    Where does this mount?
  8. Black Friday Deals @ Beefcake Racing!!!

    When will you announce the discounts on DSS and G-Force?
  9. Viking Crusader Shocks do work!

    Not 0/0 on the street but I turned down to like 3c 3r to avoid breaking stuff on rough roads. Around 6c 9r worked ok on the track, but tweak as needed,
  10. Steeda RLCA spherical bushing installation?

    You just need to tap the threads for that hole.
  11. AFR Stuck at 14

    It doesn't default to the stock tune, but since it can't read the air fuel it defaults to the stoich of pump gas. Which, if on e85 will probably cause engine damage if you run long term.
  12. North Carolina Steeda S550 Camber plates

    PM sent, I'll take them if they are still available.
  13. Post Pix of your S550 with aftermarket wheels and tires

    SVE R350 wheels 19x10 285/35/19 19x11 305/35/19
  14. Holley sniper intake/ID1050X injectors

    Just make sure you run the injector spacers on the 1050x that make the injectors the same height as stock injectors.
  15. Need guidance on wheel/tire setup

    Are you looking for these supersnake wheels? btw the wheel gap can stay the same or close with a 19 or 20. its all about the tire height not the wheel size.
  16. Rohana RC9’s on my ruby red CS

    I tried to order a set of rc9s Yesterday and apparently they’ve been discontinued.
  17. California Ferrada fr8 wheels 20”

    Do you have a picture from the back so I can see how much of the tire/wheel sticks out from the fenders and rear quarters
  18. AFR Stuck at 14

    Check your fuses and if you are using extensions they might be bad.
  19. Help! Codes galore after header install.

    I had something similar happen to me after a driveshaft install (which made no sense, but I did reroute the o2 sensor when I installed tthe driveshaft loop). All the sensors on that fuse were throwing codes. I think it can happen if there is a short in the wiring on the o2 sensors