Removing factory amp and found this

[MrTej]

I was removing my factory amp and this fell out from behind it:



anyone have any idea what this is and where it goes?

Sponsored

 

[ktp1598]

Clutch switch. It snaps back in. I can get a pic if you need it.

 

[blakedanatural]

how hard was it to get that amp out? what brand and model did you replace it with?

 

[ktp1598]

Doesn't take too long but that switch along with the OBDII port needs to come out. I took out the 9 speaker amp and installed a shaker pro amp.

 

[MrTej]

Clutch switch. It snaps back in. I can get a pic if you need it.

Thanks! Now I just need to figure out how to snap it back in. I found one pic in another thread but it wasn’t very clear on how it sits in there. I’ll also need to check the OBDII port since I didn’t know that needed to come out to remove the amp.

 

[thill444]

I removed my factory amp and did not have to remove anything else (2018 w/9 speaker Shaker system). It's just very tight quarters, you need some small socket wrenches. Also different bolt sizes which was frustrating.

 

[zero_chance]

I removed my factory amp and did not have to remove anything else (2018 w/9 speaker Shaker system). It's just very tight quarters, you need some small socket wrenches. Also different bolt sizes which was frustrating.

Exactly this. Done two now and it’s tight but no need to remove anything unless you’re so inclined.

 

[ktp1598]

I've pulled that amp several times and I always pull the OBD2 port and the clutch switch as it usually give just enough room to wiggle it out.

Sponsored