2020 Bullitt: Wheel Spacer size for flush look?

[ionpig]

Good to know, I read similar so it's good to see it. As you know the ride in these things is great, so don't feel the need to lower for any other reason than aesthetics. What's the chip you've got? US and UK HP/BHP are different, in the US the Bullitt is already 480.

Do you feel the difference?

I find that the lower end torque could be sharper. I had a Golf R back in the UK and that went like a rocket, very different car though. I drove my Bullitt back from Detroit 1700 miles to Austin I was achieving 26mpg, I don't think I've got better than 21 since! Still at $2 a gallon it's less of an issue . How much is it costing you in the UK to fill it up?

The chip is from Tunit and yes the biggest difference is the increase of torque and that I do notice. Not so much the HP gains but that all HP gain happens much higher up the rev range and the torque lower. My previous '17 GT had better torque low end and my GT500 was prodigious.

Fuel here is around £1.05 per litre (£5.00 per gallon?) On mixed driving I get around the same as you 21ish, but that does involve some larking around....

Sponsored

 

[VMBullitt]

So here it is, got the RokBlox and the UK 22mm spacers. Looks Great!!

 

[ionpig]

So here it is, got the RokBlox and the UK 22mm spacers. Looks Great!!

Looks amazing! Well worth the wait. What do you think about the quality of the spacers?

 

[VMBullitt]

Spacer quality was excellent, I had a minor issue with one of the from wheel nuts being a little longer than others so but only a mm or so. They're still torqued flush, but you can see the marks on the inside of the wheel. Need to get the alignment and balancing done too. I don't think there's any need for lowering now. It sits just right.

Also was very pleased with the RokBlox guards you can't notice them at all - Thanks for the suggestion @Mustang_Lou



Next stop, the tune.

 

[ionpig]

Spacer quality was excellent, I had a minor issue with one of the from wheel nuts being a little longer than others so but only a mm or so. They're still torqued flush, but you can see the marks on the inside of the wheel. Need to get the alignment and balancing done too. I don't think there's any need for lowering now. It sits just right.

Also was very pleased with the RokBlox guards you can't notice them at all - Thanks for the suggestion @Mustang_Lou



Next stop, the tune.

The ride is looking sweet. Be interested to know which tune you plumb for and the results.

 

[Leigh_bullitt]

So here it is, got the RokBlox and the UK 22mm spacers. Looks Great!!

Hi VM Bullitt
Does your Bullitt have mangneride?.
I thought the studs were too long and would be hitting the inside of the wheels on the front?.
Can you let me know as I’m thinking of getting 25mm up front and 22mm for the rear.
Many thanks

Sponsored