Bahndvr
Roushcharged
- Thread starter
- #1
I've read conflicting information on the correct brake bleeding for our Mustang, tried a search but didn't find anything conclusive.
There is the 2 man operation (one pumps the brake pedal and the other under the car cracks the bleeder valve until pedal goes to the floor, close the valve and starts over) and then there are two 1 man operations (push and pull basically). There is something about the brake metering block that doesn't like the pressurized master cylinder reservoir (push) or the sucking fluid out the bleeder valve (pull). One of single man operations is the correct way to bleed the brakes?
There is the 2 man operation (one pumps the brake pedal and the other under the car cracks the bleeder valve until pedal goes to the floor, close the valve and starts over) and then there are two 1 man operations (push and pull basically). There is something about the brake metering block that doesn't like the pressurized master cylinder reservoir (push) or the sucking fluid out the bleeder valve (pull). One of single man operations is the correct way to bleed the brakes?
Sponsored