Cookiemonster
Well-Known Member
- Joined
- Dec 18, 2019
- Threads
- 15
- Messages
- 79
- Reaction score
- 12
- Location
- South of You
- Vehicle(s)
- 2019 M6 GT
- Thread starter
- #1
I'm at the beginnings of a top mount TT Hellion install on my 19 GT. I'm at the part where I'm trying to remove the passenger side cat directly after the headers...but how in the hell am I supposed to break the nut facing the frame loose?
I know a ton of you have removed this piece - please help me out...I just can't see a way to get a wrench in there to get an angle. I've tried 1/2 driver with a break bar and I just don't have any degrees of motion to even start a turn. When looking at it from above, it's so far down and back that it's worse than from below.
See below picture...you can see I already have the nut facing the ground off, it's the on in the background that's completely fucking me up.
Edit - before anyone says to read the instructions - they just say 'remove remaining passenger cat pipe', and the only picture shown is wrenching on the front nut that I have already removed.
I know a ton of you have removed this piece - please help me out...I just can't see a way to get a wrench in there to get an angle. I've tried 1/2 driver with a break bar and I just don't have any degrees of motion to even start a turn. When looking at it from above, it's so far down and back that it's worse than from below.
See below picture...you can see I already have the nut facing the ground off, it's the on in the background that's completely fucking me up.
Edit - before anyone says to read the instructions - they just say 'remove remaining passenger cat pipe', and the only picture shown is wrenching on the front nut that I have already removed.
Sponsored