I’m pretty sure everything is plugged in. If it was unplugged I would have on screen continually correct. Also if I hold traction toggle for 4 seconds it tells me that Advance Trac is off. Been reading some posts, I’m wondering if the car has to be driven and all fluids up to temp, just sitting in my garage now.
The following conditions must be met to initialize Line Lock:
• The vehicle is on a level surface.
• The engine is running.
• The vehicle is traveling less than 25 mph (40 km/h).
• Selectable Drive Mode is not in wet mode (if equipped).
• There are no AdvanceTrac faults.
The following conditions must be met to engage Line Lock:
• The vehicle is on a level surface.
• The engine is running.
• The vehicle is stopped.
• The parking brake is not applied.
• The driver door is closed.
• The transmission is in a forward gear.
• Selectable Drive Mode is not in wet mode (if equipped).
• There are no AdvanceTrac faults.
• The steering wheel must be in the straight ahead position.
I've also heard the fluids have to be at operating temperature but cannot find that documented anywhere.